Both outputs are separately monitored, so that in case of error, only the affected channel is switched off.
Dynacord Powermate 1000 Mk1 Service Programs Free Of ChargeWe are committed to facilitate our own electronic-waste-management-system, for the free of charge return of all EVI Audio GmbH products: Telex, DYNACORD, Electro-Voice and RTS.Arrangements are made with the dealer where you purchased the equipment from, for the returning of all unusable equipment at no cost, to the factory in Straubing, for environmental protective disposal.Always place the PowerMate on an even surface to allow for sufficient airflow during the opera- tion.This will save you, your audience, and the equipment from extensive wear from unpleasant pops. ![]() The reproduc- tion of the instruments original sound characteristics will be unsatisfactory. ![]() Turning one of the EQ level controls to the right enhancesamplifies the corresponding frequency range while turning it to the left lowersattenuates the signal of that specific frequency band. Before you begin to alter the sound, all EQ controls should be set to their neutral position, i.e. While doing so turn the frequency rotary control (kHz) slowly from left to right. Surely and within no time, you will detect the frequency range that is not to your liking or caus- ing the feedback. Do not connect signal sources to phone and RCA inputs at the same time. The stereo channel mapping will oth- erwise appear like it is set on the keyboard the lower layer in the left and the top layer in the right channel. For more details on the functioning of these controls, please refer to the Input Mono section of this owners manual. To accomplish this function, the FX 1 and FX 2 ON switches have to be engaged. Experience has revealed that the effect level in the monitor mix has to be lower than the level in the master mix, since the distance between monitor speakers and artists is much shorter. Do not turn up the monitor systems volume higher than actually necessary. Try to avoid extensive equalization on channels that you want to include in your monitor mix. The indication range of the LED-meter is 40 dB, indicating the levels that are present at the master outputs in dBu. CAUTION: The signal feed to the internal power amplifier is also interrupted. MASTER A OUT LR The signals at the MASTER A OUT LR outputs are post master fader and mainly meant to feed additional, external power amplifiers. We recommend using the gooseneck lamp (DC-LITLITE-4P), available from the DYNACORD accessory assortment. The EQs insert point is post master fader and pre power amplifier. The EQ is bypassed when the EQ ON switch is not locked in its ON.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |